GSS23GYPFCFS General Electric Refrigerator - Instructions

Pulled out broken drawer and inserted new drawer...just that simple!

The internal water line was leaking. I could not find any repair parts for my refrigerator but the GE 5/16 water line was the same size. I purchased 6' of tubing and two unions. Make sure the clean and square. If possible, make the cuts in a spot where you can use the pliers and wrench to tighten the union. I cut approximately 2' out of the existing line and replaced it with the same length of new line using the 2 unions, one on each end. Took about 5 minutes.

I replaced the original solenoid, which had rusted into one solid piece. OMG how easy was that!

The only difficult part was not knowing which parts had to be removed to gain access to the flapper to replace it. It appeared as if the frame around the control panel would have to be removed as well as the door handle; we tried but were not able to remove the frame. It turned out that the panel just popped out with the frame in place. Once we had access to the flapper, it was easy to replace it. The repair fixed the problem.

Cut old tubing in frig with wire cutters and pulled through the bottom wall and removed old tnak from the wall...Installed new tank and ran tubing down trough lower wall and connected to the valve and the freezer door.

Opened, discovered not flapper but more complicated

just watch video simple

First tried just replacing flap/spring and mounting. Still did not work so then order a new solenoid with piston that attaches to mounting. That solved problem completely. Corrosion around piston prevented fluid movement of flap. Easy fix after watching video. Saved a bundle I'm sure. Thanks !!!

Remove front cover did not remove wires remove ice and water unit took off flapper put new one on 5 minutes back together

ordered a new one; took 1 second to put in.

Researched on internet/you tube; ordered part, and did the repair. Easy to do and saved the cost of a service call.

The only tricky part was removing the front panel. Releasing the latches required considerable force. The best tool I found was a "jack knife" type Allen wrench set, using the medium size wrench, which fit into the release hole and upward pressure did the trick. The rest of the job was very easy.

My wife did it in less than five minutes

Instructions are available by internet or even a video from a handyman. Pull fridge, turn off water supply and disconnect power. Remove lower panel in back of fridge, remove water line from quick disconnect plug - transparent line (just push white plug and pull line (careful with residual water - not much on back plug). Remove bottom front grill and disconnect water line from quick disconnect plug at bottom of freezer door - watch out for water. Remove bottom three panels in the fridge and unscrew water tank, pull it out with the water lines. Insert water lines through holes and screw in the water tank. Connect water lines to their respective quick disconnect plugs. Turn water on and power on. Replace back panel and front grill.

Replaced Temperature Sensor and now it is getting cold.