MGDB950YG2 Maytag Dryer - Instructions

had no room to work in the back of the dryer

After the Radiant Flame Sensor was installed, the problem remained. An appliance repair person then replaced both coils, and that fixed the problem.

Exchanged old for new.

i removed the old lens,then removed the bulb,after ordering and receiving your replacement lense,it went back on just like the old one.the repair was very easy. thank you. D.S P.S1 IAM A REPIARMAN NOW!!! WITH YOUR VIRTUAL REPAIRMAN APP,VERY VERY SMART ILL SPREAD THE WORD.

Removed the lower front cover of the dryer. Removed the lint filter and removed the cover from the air duct by removing two 1/4" bolts. Removed the two 1/4" bolts retaining the thermistor. Installed the new thermistor and covers.

We followed the on-line video which was very helpful but it took longer for us. But the part didn't fix the problem, so we had to go back on line and research it some more only to find that the more common cure for our problem was the gas coils which were even easier to replace and that did fix the problem.

I ended up taking the entire dryer apart when I didn't need to, and it turns out it wasn't the Igniter Kit in the first place but the thermal fuse in the back. Was pretty simple to repair in any case however.

Very easy to replace, just removed the door catch and place the new one in and push till clicked. That simply.

The part came in very quickly. If you know how to remove the front panel, it is very easy to repair. The hard part is to diagnose the problem. The first thing to check is the igniter. If it comes on then you look for faulty limit switches. If you have lots of training in electronics and appliance repair this is very easy, if you do not I would not try this. I have 40 years in the repair business, It still took me 1hr. to find the problem. the switch was intermitted, one time the dryer would work the next time it would not. Good luck and happy repairs.

Unplugged dryer from power source, used putty knife to release latches that hold top on, tilted the top out of the way, unplugged door lite, located the radiant switch, removed 1 screw,then undid 2 wires & lifted out switch. Reversed procedure plugged in dryer....wa la had dried a large load of clothes, took 1/3 the time to dry clothes at last. Thanks "PartSelect"

Followed the easy instructions on the video, and it worked. Sure beats calling a technician.

Just put the new lint filter in.

replaced with new one which had been improved upon by a brace down the middle of the screen.

The door catch dislodged in the door and apparently broke. The hardest part was getting it out of the door because in trying to remove it, the piece fell into the inside of the door. I could have easily just installed the new part (it snaps right in with great ease, that part took exactly 5 seconds). But hearing that old piece rattle around inside the door would have made me a little nuts. So I decided to take the door apart to retrieve it. It was just a bunch of screws from around the perimeter of the door, but I also had to unhinge it to do the job. Putting the door back together wasn't as easy as I had hoped, with some pretty tight fits and the glass dislodging. Had a few moments where I was regretting. But I got the old part out, snapped the new one right in. I'm sure an appliance guy would have charged me $60 - 90 just for coming out. Instead I repaired the dryer for the cost of a $3 part. One small lesson learned here -- dryer doors are much like refrigerator doors, or at least mine is. There is a door catch on both sides of the door so you can hinge it to open either way. I could have done the repair for nothing! But I love parts select for just this reason. I don't do major repairs, but replacing pieces on appliances couldn't be easier with this service!

Replaced Lint Screen