JVM1330WWC02 General Electric Microwave - Instructions

I first read the previously posted directions from other customers that were sent with my part order confirmation, which were all very helpful. Then, I basically used a screw driver to unscrew the screw holding the lens cover in place - be careful as it is a very tiny screw and it can easily fall behind your oven. You might want to place a large piece of cardboard over the space between oven and wall, as I did, so that you don't lose the screw in case it falls. Next I pried open the prongs, carefully slid out the cracked lens, and slid the new lens in place, pushed back the prongs and put the screw back in. I found that it was easier to use my fingers to first place and tighten the screw because it is very small and will keep falling out of place if you try to just use the screwdriver. Good luck!

thank you for the video--very clear, responsible, applicable although the illustration was not exactly of our kind of light. the bulb was exactly like the one Hotpoint used in its microwave made in 1989! I will come back to you for parts in the future. (You have the model # from my original order.)

3rd handle replaced,(glued first two together), and used an electric screw driver to put screws in tight this time. And you think that FORD has a better idea. Jeffery has a great idea... make it to break and get rid of repairmen. $65.00 for the part and shipping is way more than its worth...especially if they keep breaking.

Slip a flat bladed screwdriver under the gasket near the bottom screw and lift it out far enough to reach the screw with a phillips screwdriver. Top screw is exposed and comes out easily. Tighten both screws, push the gasket back in and you are finished. 5 min tops.

Simple. The parts came instantly. The glass was too big so I had it cut to size. I unscrewed the fixture with a screw driver replaced the bulb and slipped the glass cover into the frame and screwed the whole assembly in.

Removed a rubber seal on the inside of the door. Removed the two screws holding the old handle. Put the new handle on and screwed it in. Took less than 5 minutes.

Removed difuser (one screw), removed old bulb, screwed in new bulb, replaced difuser.

I read the instructions posted by others. Removed the visible screw from the inside of the door at the top, pulled the door gasket covering exposing the bottom screw. I reattached the new handle. Viola. Thank you.

I loosened the screw that held the top of the handle onto the door of the microwave, and also removed the gasket on the inside of the door, exposing the bottom screw holding the lower end of the handle to the door. I removed the old handle parts and placed the new handle in the proper location, and then screwed the handle into place. I replaced the gasket, and I was done!
It was painless.

Tyring to get bulb out i ruined the light socket. Unscrewed the bottom cover of microware. Took out screw holding light socket, removed wires to socket with pliers, intsalled new socket. It was a piece of cake and the part was a perfect match.

Screwed in new bulb.

Had already reverse engineered the door and it's parts so when the repair parts got here I already knew how the parts fit together. Took me 15 minutes max without instructions.

pluged wires back on ,placed lamp holder and bulb back and replaced screws

Removed one screw, installed new lense in lense frame, rescrewed. Done.

Replaced the sockets, lens and bulbs. The first time the new bulb was touching the lens and the heat broke the lens and burnt out the bulb. The second time I adjusted the socket so that the bulb does not touch the lens.

Impressed by how quickly the parts arrived after the order was submitted. Two days.

Thank you.