JVM1330BWC01 General Electric Microwave - Instructions

We planned on buying a new microwave but thought well, we would see if there was a part available for a 13 year old microwave. Lo and Behold! Partselect.com had one! It was shipped and we got it in a couple of days. By reading what others (professional installers) said about putting the new handle on, I was confident to let my husband tackle this on his own! We saved a service call and now it works like new!! Thanks

ordered the handle it was so easy to installed with help fron do it yourselfers.thanks

I asked a handyman at the local fitness center about repairing it and he refered me to your website where I found an exploaded drawing showing the parts I needed and how to get to them. It was great and very easy.

Used thin spatula to remove plastic frame around inside of door to expose bottom screw. Removed top and bottom screw and pulled off broken handle. After cleaning up the outside of the door, installed new handle and tightened screws. Popped plastic frame back into place: done!

so easy, but how do i turn light off?

Part recieved next day. thanks so much

My son=law did repair because I am elderly and it was necesary to remove the bottom plate of the microwave which I was unable to do. The microwave was installed in 1987 and I believe this was the first time to replace the bulbs. When my son removed them the bulb was diintergrated. That's how old they were. Once he was able to remove the underneath plate the repair was easy except for removing the old bulbs. I think that I could have done it myself but he was available and I am sure it was done much better. All in all the parts)bulbs) were correct and everything is workiin fine. This is a good place to order replacement parts. In fact I am going to order a new charcoal filter. He took the label off the old one and I am ordering the replacement. After all 1987 may have been a good year, but time for a new one. Mary

2 screws out 2 screws back piece of cake

Just unscrewed the screw holding the lens, unscrewed the bulb and put the new bulb in. Simple

My son repaired it. The difficulty was because there was no schematic included and we couldn't figure out how to access the screw at the bottom of the handle. My son downloaded a schematic from the internet and finally figured out how to do it from that, but it would have been a lot quicker and easier if one had been included with the part. I was very satisfied, however, with the speed of the delivery.

Unscrewed the lens, it hinged down, then I could remove the frame. Pulled old bulb out and replaced with new one. Replaced broken glass in frame. Reset hinge into the holes and swung it up into place. Screwed it in.

Very easy!

All one has to do is use a screw driver to remove the screws, one per lens.
Then lower the lens bracket, bend the 4 tabs holding the
lens, remove and replace the lens and screw the brackets back in place.

Less than 10 minuits.

changed the bulb

Believe it or not, all the advice given by others was right on the mark. Unscrewed the top piece, worked the seal off, which was easier then I worried it would be, removed the screw from the broken piece and reversed the process. Even my wife was surprised I was able to complete the repair with no problems. THANK YOU for the help. Bill

Followed the instructions from the do-it-yourselfers on your web site which were all excellent and a wonderful asset to your site. It took us much longer than 5 minutes (about 20 min.) because we couldn't get the bottom screw out and then had one heck of a time screwing it into the new handle. Don't know if the srew was too long, too big or what, but we feel confident that it won't fall out!

removed the lens cover with one screw and replaced bulb