JDB9200CWP2 Jenn-Air Dishwasher - Instructions

Easy. Part just snapped in and took all of about a minute. Now the top rack doe snot slide back and forth.

Remove power source, then remove old power cord.Run new power cord through existing opening ang attach to existing power box on bottom o f dishwasher. Install electrical leads and device ground. Reinstall cabinet bottom. Check out operation by running a cycle. All ok!

Pushed to be into place

My husband called Part Select and described the problem. After we sent a couple of photos to the technician, she determined the part that we needed...a top rack assembly unit...and it arrived within a few days.
I watched the video that Part Select provided and it made the job so much easier than if the new part had been sent with a booklet of diagrams and written instructions. The video showed exactly how to dismantle the old part and then install the new part. It was also helpful to compare the part I was working with to the same part on the other side of the rack so that I knew for sure that I had it positioned correctly.
The part and shipping cost about $70. It would have cost more than 3 times as much if I had to call a repairman.

Disconnected the water hose entering and one electrical plug alone with one screw that holds the valve to the machine. Replaced the old with the new and it worked.

followed directions, a kid could have done it,

Test heater circut, was ok. Pulled front panel door and replaced control board. Washer works as designed now.

I just looked at the matching piece on the other side of the rack and used it as a guide to install the new part.

I watched the provided video and followed the very easy installation instructions. It was awesome.

Slid out dishwasher removed 2 screws put new slide in an tighten screws. Pushed back in rescrewed to counter and was done.

Upper basket removed because I could not take half the retainers

Our new drain pump arrived with 2 clips broken. So we switched the housing with the old pump and installed
Used youTube video for step by step instructions

I followed the video and even though my dishwasher was slightly different from the one shown, everything worked well. I was lucky that I had enough clearance to pull the dishwasher away from the countertop far enough to make the repair, without having to remove any dishwasher wiring below. I replaced both side tracks, even though only the left side was broken.

Same procedure as described elsewhere. Very good idea to replace both left and right tracks at the same time since the majority of the repair effort is to simply remove and replace the dishwasher unit from the cabinet.

Had a repair man tell us we couldn't get parts. He was misinformed. Looked up model, went on line and ordered parts I thought I needed. Turned out only need control panel. Took door panel off ( need to support door panel so it won't fall off) unplugged wires using flat head screwdriver to release clips removed control panel; there's a small release lever at the top then slide panel left until it clicks. Once out, repeat steps in reverse. I am in no way handy but this was pretty simple. I did watch U-Tube video on how to remove the control panel first.