DDW361RAB-PDDW361RAB0 Amana Dishwasher - Instructions

First I removed the old door gasket with a needle nose pliers. Second cleaned the area of old residue and third installed the new gasket by hand. I needed to trim the gasket by about 2 inches then it fit and worked perfectly. No more leak!

Took old gasket out and installed new gasket. Tested unit and all was dry. Door took more effort to click shut. I knew I had a good seal.

Pulled out gasket and replaced with new one. Leaking continued until one cycle was run. . . . Gasket needs to be wetted which could have been a small piece of papaer instructing repairer to do so. Suggestion . . . Add a short intructio sheet for replacing parts.

The replacement was easy. The parts fit fine. I had to figure out how they fit. After a couple of tries, I got them positioned right. A diagram might have helped a little. They were reasonably priced. The diswasher is good for another 5 years.

Initially, I replaced the copper water intake line with a flexible line because after running it one time, I removed the lower front panel and saw water dripping from the lowest part of the copper line. That didn't fix the problem. Then I removed the black door gasket, cleaned it up and reinstalled it. That didn't solve the problem. I read some of the other similar stories on this website and instead of just ordering the door gasket, I also ordered the soap dispensor latch grommet, just in case. I recieved the parts very quickly. Instead of replacing both parts, I just replaced the door gasket just to see if that was the problem. It must have been, because I haven't seen a leak since. Eventually I will replace the grommet, just because I have it.

I removed six screws from the inside of the door panel and lifted up the panel to access the Wax Motor. I disconnected the two wires from the bottom of the motor and unclipped the motor from the panel. I reconnected the two wires to the new motor, installed the new motor, which just clips into place. I Reattached the door panel using the six screws. Everything is working fine again.

All I did was put the new wheels on. They were really fast with shipping. I put my order in one day and the parts were there the next.

We have hard well water and the gasket was in poor shape and time to be replaced. Very simple to just pull out the old gasket and put the new one in place. The gasket just needed a little bit of manipulation to properly fit from end to end. No big deal at all.

The old part had already broken off. My husband took a few minutes to see where it went and then snapped it on. It was a breeze.

remove and replace with tip of screwdriver

Removed old gasket. Cleaned groove. Install new gasket pushing it into the groove with my fingers

replaced door gasket

There is an online video on how to replace a door gasket on a dishwasher. There are no tools required to do this and it takes less than 15 minutes to do this. And best of all, it resolved the problem. No leak now.

Pulled D/W out about 1/4 of the way. Kept door latched at all times. Replaced plastic links with new ones. (one was broken but replace in pairs!). Attached springs. No tools required for this. Pushed D/W back in place and secured screws to top. Only tool used was a nut driver to remove the screws holding the D/W to the counter. Total time 7 minutes.

This was the easiest repair I have ever done! Ordered in a few mins, and received the very next day. Opened the box and installed the two wheels - Done. That was Easy! Thank you so much for such quick service! Most definitely will use your company again in the future.