58714019413B Kenmore Dishwasher - Instructions

It took me about 30 minutes to do the repair - took my time and could’ve done it much faster.

Just take you time take pictures of wires watch utube

open dishwasher, pull out bottom rack, unscrew nut, install nut into sprayer arm, then with a clockwise motion screw sprayer arm with nut on to receiver until sprayer arm spins And nut is tightened. also i would like to thank PARTS SELECT FOR THE SPEEDY DELIVERY. THANK YOU

First I pulled out the old gasket, used this to measure for the new gasket, cut to right length, pushed new gasket into the track and washed a load of dishes. No leaks! This took about 2 minutes to complete.

Removed the screws holding the dishwasher in the counterspace. Pulled it out far enough to re-attach the new spring, scoot it back in place, and put the screws back to hold it in, and attach the plate to the bottom that was taken out first. Good to go.

I snapped on the new roller and bingo! problem solved.

Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.

Never worked on a dishwasher before but quickly learned that on this particular one, it's only this thin little brass nut that tightens down the element from the underside of the washer. If not tight enough, water drips right down onto the electrical connections. In this case water began to drip and the heat from the electrical current began melting a clear rubber shield thing. Luckily I was home during the cycle and figured out the problem. Great website that seems to have all necessary parts for my washer. Quick shipment!

Snapped the new one in. One second repair - like new.

So easy it shouldn't even count as a repair, really. The dishwasher, there when I bought the place, had a lower rack that wouldn't roll out as it should. That's because there were no wheels on the left side.

The rack lifts out easily. These wheels snap on to small protrusions from the wire rack.

Snapped new wheels into place on the axel. New wheels were exactly like the old ones

We pulled the dishwasher out enough th expose the sides where the springs are attached. We removed the oldsprings and attached the new ones. Then put the dishwasher back in place.

I pulled out the dishwasher removed the two heating element insulated wires and removed both threaded brass nuts and replaced them both. Problem solved. Luckily I have a local parts and repair store with a repairman that knows every part of every appliance ever made (no kidding, I have yet to stump him with a part or question). He did not have the parts, told me to go to partselect.com order two nuts, replace them both at the same time, and fix it myself because its an easy repair and not worth paying hundreds of dollars, if you can use a wrench. He was right, and partselect.com had the right parts, at the right price, easy to find and order, and I can impress the wife with my repair skills. Thanks again!

The 'kick plate' had to be removed, and the feet had to be raised to lift the unit over the floor. the old spring could not be found, and while lying on the floor my husband had to 'feel' for the attatchments to hook up the new spring. The unit was then pushed back and the legs dropped and the unit attatched to the counter. All fixed - - thank you PartSelect for having the right spring.

Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.