25361789013 Kenmore Refrigerator - Instructions

I unscrewed the old drawer support rail and installed the new one. The phone rep. was excellent. He listened to what I needed, looked up the parts for me, and sent me the correct parts the first time. I think the parts arrived within two days, much faster then I expected. I will be doing business with you again whenever I need parts. Thank you for your excellent service. You exceeded my expectations.

Sincerely,

Rob Ponitz

First, remove shelf unit from refrigerator and lay glass side down on a large flat surface. Observe, then pay attention to assembly. Spent more time with this, drinking coffee, and playing with puppy, than the actual repair. Only had to remove and replace two
phillips head screws. Replace deli - meat drawer after shelf unit is in place in refrigerator. Check for clearance for door to close.

As others have noted: this is an easy repair. I spent more time clearing all of our containers of yogurt that the actually "repair."

This is a good opportunity to clean the glass shelf and so I did that after removing it. Unscrewed the back support screw, removed old rail, and installed new one. (I just used the old screw as it seemed to be in good shape).

Took longer to clear the top shelf to remove it from the refrigerator to do the repairs. Super easy!

removed shelf. took out screw. replaced support

Very, very easy problem to fix. I took the shelf that the support rails were attached to out of refrigerator. Unscrewed broke piece and screwed in new support rail and simply slid shelf back into refrigerator. Ta~Da! If I can do it, you can do it!

Unscrewed the screw that held the suport rail to the shilf and changed the rail. Then I screw in the new rail.

first i removed the screw from the back of the shelf then pulled the old rail off. I sliped the new rail onto the post then replace the rear screw.

I unscrewed the old drawer support and screwed the new one in. It was very simple!

It was easy. I handed it to my husband.

This was a truly easy snap-in repair. Because I live in a small fishing village on the coast of Venezuela, the only difficult part was waiting for the part to arrive. I'm very grateful that Part Select makes ordering parts easy and reliable.

I took out the screw and removed the old rail, then I used the same screw to install the new rail. It took me 2 to 3 minutes. Very easy.

I Removed the old broken piece and replaced it with the new drawer support, using the screwdriver it was a very simple operation.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.