25361783011 Kenmore Refrigerator - Instructions

removed shelf. took out screw. replaced support

Very, very easy problem to fix. I took the shelf that the support rails were attached to out of refrigerator. Unscrewed broke piece and screwed in new support rail and simply slid shelf back into refrigerator. Ta~Da! If I can do it, you can do it!

Unscrewed the screw that held the suport rail to the shilf and changed the rail. Then I screw in the new rail.

first i removed the screw from the back of the shelf then pulled the old rail off. I sliped the new rail onto the post then replace the rear screw.

Repair was quite easy. Simply remove screw and replace part. My repairman charges a min. fee of $99 to come by. I did this myself and saved an easy $100! The part came very quickly--next day after I ordered it. Would definitely do this again.

I unscrewed the old drawer support and screwed the new one in. It was very simple!

It was easy. I handed it to my husband.

This was a truly easy snap-in repair. Because I live in a small fishing village on the coast of Venezuela, the only difficult part was waiting for the part to arrive. I'm very grateful that Part Select makes ordering parts easy and reliable.

I took out the screw and removed the old rail, then I used the same screw to install the new rail. It took me 2 to 3 minutes. Very easy.

I Removed the old broken piece and replaced it with the new drawer support, using the screwdriver it was a very simple operation.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Super easy. We unscrewed the broken rail, and screwed the new rail into place. Much easier than expected!!! We were also pleasantly surprised to have the part arrive the day after we ordered it!

took off bad part-- 1 screw-- took every bit of 3 min. to change

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.

The shelf needed to be removed from refrigerator and then remove the screw and pull the rail from the bracket on the opposite end. After installing the new rail it turned out to be a fraction of an inch too long so I had to file the cracket on the shelf which is metal. The rail slipped back in and was perfect. Easy job.