22307 ((1988)) Kenmore Range - Instructions

Unplugged the old element and plugged in the new one.

The best part was it arrived less then 24 hours after I ordered it. Unbelievable, thank you.

I was delighted to find that the parts to a Jenn-Air range which was new in 1985 were available from PartSelect.

Website very user-friendly; shipping immediate; parts were just right; they fit and they enhance the range tremendously.

I was 100% pleased!

Just replaced old with new, it plugs in same as old.

Removed and replaced infinite switch ; removed and replaced both cartridge so that they matched

manual instructions were included in the email notification re' shipping confirmation

Replaced unit

I watched a You Tube video,removed and dismantled the door, installed the new hinge. I forgot to remove the small pin which is similar to a rivet. When I tried to close the door it bent. Eventually, I remembered the shipping pin and pulled it out with any damage. Believe it or not, I had read about the shipping pin on customer comments on PartsSelect...Good luck, it is relatively easy!

Remarkably easy. We had purchased a Jenn-Air with 2 burners and a grill. We found we rarely used the grill feature. We needed more burners. We looked several years ago but it was quite expensive to replace so we suffered through it. I decided I had to find the replacement part or purchase a new stove. I found your website and was shocked to see you carried what I needed. The new part was half as much as we previously priced it for. So, we ordered it and it worked immediately. Thank you so much. Saved me from buying a new stove. Linda

My old burners pluged in. I pulled out the old burners unpacked the the new burners pluged them in. I turned on the new burners and tested themand they worked!!

Opened oven door, took four screws out of the front control panel, removed the two screws holding the burner control switch to the front panel, removed the wires from the old switch one at a time and installed them on the new switch. secured the new switch to the front panel, put the four screws back into the front panel, and closed the oven door. Real easy repair.

just plugged it into the unit

Took out of box and plugged into slot.....even I was capable of doing this....easy

The only problem was the little push nuts that came with the new part were too small for the posts on the stove top. I had to go to hardware and buy some for about 10 cents that fit. Other than that, everything was great. Great service from this company!

Pulled out the old one, pluged in the new one. It took me longer to open the box! PartSelect made it so easy to order and the shipping was super fast and at low cost. I looked on ebay and saw people paying more (with shipping and handling) for used parts. Thank you PartSelect!

I took out the old heating element and pluged in the new one. Very simple. Just like putting a plug into an electrical outlet

We ordered the part for replacement. You sent it and we just put in on the stove. It was exactly what we wanted.