Control Board with Buzzer
$102.44
Special Order
PartSelect Number
PS755814
Manufacturer Part Number
WE04X10102
Manufactured by
GE
Troubleshooting
This part works with the following products:
Dryer.
This part works with the following products:
General Electric, Kenmore.
Part# WE04X10102 replaces these:
AP3421740, 963500, WE04M0223, WE04M0272, WE4M223, WE4M272, WE4X10102
Customer Repair Stories
Average Repair Rating: 2.3 / 5.0, 1 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Dryer would finish before clothes were dry
Took it apart including taking drum out. Heating coils were ok, so an experienced friend suggested the PC control board. I vacuumed out the inside frame, air duct, re-glued some loose foam seals and also lubricated the sleeve bearing. When the parts came in I put it back together with the new belt and PC board. The dryer works correctly now.
Other Parts Used:
-
Robert from Folsom, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers
1 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bud
July 14, 2021
Dryer does not shut off on any auto-dry settings. Clothes are hot and dry but cycle never ends. Timed setting works fine. Cleaned moisture sensing probes. Good continuity from control board to end of upper probe. Good continuity from end of lower probe to ground. Tried measuring upper probe voltage when running with dry clothes and barely got a reading, under 1v. Seems to me that points to a bad control board. Are there any additional tests I should do to prove my theory. I don't want to spend $80 just guessing. Thanks so much.
For model number DPSR610EG7WT
Hello Bud, Thank you for the question. With the information we have it would suggest the control board is defective. There is no additional tests to be done unfortunately without having a repair man come in and see the appliance. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS755814
Manufacturer Part Number: WE04X10102
Manufacturer Part Number: WE04X10102
Brand
Model Number
Description