![Customer Service Representative](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/images/csr-partdetail.jpg)
CONTROL TACTILE Assembly KIT
$256.85
Special Order
PartSelect Number
PS4704220
Manufacturer Part Number
WD21X10505
Manufactured by
GE
Troubleshooting
This part fixes the following symptoms:
Will Not Start
This part works with the following products:
Dishwasher.
This part works with the following products:
General Electric.
Part# WD21X10505 replaces these:
WD21X10470
Customer Repair Stories
Average Repair Rating: 3.3 / 5.0, 1 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Everything dead
1. Troubleshoot: Unplug, check power at outlet (OK), disassemble front door (phillips screws) from inside, remove safety switch cover to check operation (OK), remove metal shield over ckt board. Noticed burned and separated transformer leads. No repair possible, ordered new board(s), arrived promptly. 2. Replace: Piece of cake--remember to check for jumpers, had to remove one from old board and put it on the new one.
Other Parts Used:
-
Jeremy from TAOS, NM
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Lavern Leek
October 14, 2017
Is the control panel black
For model number GLD5604V00BB
Hello Lavern, thank you for contacting us. The correct part number for the control panel would be PS3650593 this would be black. Good luck with the repair!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Lavern
October 17, 2017
A GE dealer shows a part # wd34x11784. Did i order the same part or did i order something different? Don"t want to get the wrong part.
For model number GLD5604V00BB
Hi Lavern,
Thank you for your question. If you are looking for your touchpad this would not be the correct part. I have listed the correct control panel/touch pad according to your model number below. I hope that helps. If you are looking for any other parts, always look underneath your model information and the parts you see there will be correct. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Gerald
March 15, 2023
I bought and installed your kit. After the Test/calibration mode I was able to run the dishwasher once. It will not start. I've turned the power off for an hour and when I turn it back on the Clean light blinks. The Options and Cycle lites have not worked following installation. It appears the circuit boards are faulty. Can you offer some advice?
For model number GLD4560V00SS
Hi Gerald, thank you for reaching out. Based on the description that you have provided, we would recommend checking the interlock switch, part number PS1021382, and check the control tactile assembly kit, part number PS4704220, for continuity. To test the control board properly, touch the multimeter probes to the test points present on the board. Make sure while doing this step that you have your hands on the plastic portion of the probes. You can then go on to check either the voltage or resistance. When measuring the resistors’ resistance, connect one probe to the end of each resistor. We hope this solves your problem!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Eve
December 24, 2023
Dishwasher works except for the Rinse cycle which sometimes functions - perhaps 1:50 times tried (!). Is this the part that we need or do we need a different part?
For model number GLD5664V00SS
Hi Eve, thank you for reaching out. Based on our research, the issue is with the tactile control assembly. Yes, you may need to replace the tactile control assembly, part number PS4704220, that you mentioned, to fix the issue. Good luck with your repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Donald
November 17, 2019
GLD5604VOOWW Sanitize cycle works but not regular cycle
For model number GLD5604VOOWW
Hello Donald and thanks for writing.
We have attached the link to the manual with the troubleshooting section We hope this helps. Please contact us anytime.
http://kitchen.manualsonline.com/support/ge-appliances/dishwasher/i-need-a-manual-for-general-electric-gld5604vooww-5697891
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS4704220
Manufacturer Part Number: WD21X10505
Manufacturer Part Number: WD21X10505
Brand
Model Number
Description
![Customer Service Representative](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/images/csr-partdetail.jpg)