![Customer Service Representative](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/images/csr-partdetail.jpg)
TUBE Valve SUP
Fits your 36271768890!
$62.35
Special Order
Fits your 36271768890!
PartSelect Number
PS240771
Manufacturer Part Number
WB28K147
Manufactured by
GE
Troubleshooting
This part works with the following products:
Range.
This part works with the following products:
General Electric, Hotpoint, Kenmore.
Part# WB28K147 replaces these:
AP2026862, 255914, WB28K0147
Customer Repair Stories
Average Repair Rating: 2.3 / 5.0, 1 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Oven was popping house breaker on ignition.
Removed oven racks, oven floor tray and shield to access burner. Initially began to replace only electric igniter (just two screws) and burner break valve but noticed burner tube was corroded and had large hole near igniter. Ordered a new burner pipe. Hardest part of this repair was the burner valve. It has a compression fitting to the aluminum supply tube that needs to be seated well without bending the tube. The electrical connectors (2) have plastic shields on them that are somewhat brittle, perhaps because the oven is about ten years old. Had to be very gentle with them when swapping them from old valve to new so as not to crack the plastic.
The real trick was figuring out that the valve break needed to be adjusted for LP supply. It shipped configured for natural gas. Upon initial install the flame level in the oven was much to high. After asking around I discovered that the brass nozzle needs to be tightened down clockwise with a wrench until flush with the base in order to set it for LP.
The real trick was figuring out that the valve break needed to be adjusted for LP supply. It shipped configured for natural gas. Upon initial install the flame level in the oven was much to high. After asking around I discovered that the brass nozzle needs to be tightened down clockwise with a wrench until flush with the base in order to set it for LP.
Other Parts Used:
-
DAVID from SOUTHAMPTON, NY
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
15 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS240771
Manufacturer Part Number: WB28K147
Manufacturer Part Number: WB28K147
Brand
Model Number
Description
![Customer Service Representative](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/images/csr-partdetail.jpg)