Average Repair Rating: 2.8 / 5.0, 1 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Quit Heating at once
Swung back lid, unscrewed front vent from inside, ( 3-screws ) and front appliance cover to get to the heating element. Removed, discovered broken coil, ordered part online, received in 2-3 days with no additional shipping charges. Went back to working right away ! Great, fast, hassle free. If I need a part again for my home appliance's, I know who to call.
Other Parts Used:
Dawn from Erwin, NC
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
5 of 17 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Michael
January 22, 2019
No heat in dryer. Was advised it was the heating element. Install a new element and was not the problem. Requested that installation instructions be sent. Did not happen. Advised by partsselect to contact Whirlpool. No one answers my phone call. I need you help. Mike viele 460 361 3799
For model number LT7000auwo
Hello Michael, thank you for your question. If the unit isn't heating at all the most likely issue is a thermostat, not the element. We would recommend testing the thermostats in the unit to determine which one or ones have failed. You will want to test the Cycling Thermostat - Limit 135/155 PartSelect Number: PS11743793, Thermal Cut-Off Kit PartSelect Number: PS334278, and the Thermostat Heater PartSelect Number: PS11743292. To test the thermostats you will want to follow these steps. Dryer thermostats are usually oval shaped and about an inch and a half in length. Also, there should be two wires leading to each thermostat. Label these wires before you remove them so that you are able to correctly reconnect them later. The wires leading to the thermostat are connected using metal slip on connectors. Remove the wires by pulling on the connectors, and not the wires themselves. It may be a good idea to use a pair of needle nosed pliers to help you. Set your multimeter to the R X 1 setting. Take each of your meter's probes and touch one to each terminal. You are testing for continuity, and you should receive a reading of either zero or infinity. At room temperature, testing the thermostat should produce a reading of zero. But if a thermostat is tested when it is heated to its limit, a reading of infinity should be produced. We strongly recommend that you test your thermostat at room temperature. If the test you conduct with your thermostat does not produce these results, then you should replace the component. I hope this helps!
Was this helpful?
Thank you for voting!
Kerry
December 27, 2022
Dryer getting too hot to touch - s/n 12815169GC
Possible element ?
For model number SDE305DAYW
Hello Kerry, thank you for contacting us. The most probable culprits are the following: the high-limit thermostat, part number PS11748479, the cycling thermostat, part number PS11741918, and the heating element assembly, part number PS2039492. We would recommend checking these parts with a multimeter to pinpoint the faulty one. Customer service is available 7 days a week if you require assistance placing an order. Thanks again for reaching out!
Meant as a backup to a high limit thermostat, this fuse is typically set to trip at a higher temperature than that of a high limit thermostat. This is a one-time use fuse, so when it does trip, you do need to replace it....
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS2039492
Manufacturer Part Number: 37001139