Ice Actuator
Fits your CRSH232PW6!
$90.80
Special Order
Fits your CRSH232PW6!
PartSelect Number
PS1526378
Manufacturer Part Number
241681901
Manufactured by
Frigidaire
Troubleshooting
This part fixes the following symptoms:
Ice maker won’t dispense ice
This part works with the following products:
Refrigerator.
This part works with the following products:
Frigidaire, Westinghouse, Crosley, Gibson.
Part# 241681901 replaces these:
AP3965487, 1196647, 5304421826, 5304456873
Customer Repair Stories
Average Repair Rating: 3.8 / 5.0, 4 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Ice actuator broke.
Replaced ice actuator.
Other Parts Used:
-
Tim from Liberty Township, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
24 of 36 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice Actuator broken, Door Closing Cam, Door Closure/Hinge Bearing
Unplug refrigerator. Take out spill tray by sliding out. remove bottom 3 screws, gently but firmly push up and against refrigerator(Top section of cover snaps in by pulling cover down while holding cover against refrigerator). There is a ribbon wire connecting the two boards, care not to tear it out of connectors. There are two tabs on the plastic connector holding the ribbon wire to the outside board,pull the tabs out a little and gently pull the ribbon loose, carefully. There are 3 screws holding in the back board, remove them, them remove water hose from water actuator so the assembly can come out. Gently spread the plastic holder to be able to take the broken paddle out. Watch closely how the third arm on the actuator(Lower left arm)is resting on the back of the flapper.Replace the Actuator exactly the same. Just reverse the steps to install the rest of the parts.(Had a time getting the water hose back into it place. I used pliers to push and wiggle it back into it opening).Don't forget to plug the frig back in again. DOOR CLOSING CAM AND HINGE BEARING ARE VERY EASY. It take about 10 to 15 minutes to do. Empty door drawers before procedure the screw holding the plastic cover, remove cover. I used a 3/8" nut driver and my cordless drill to take out the two lag bolts holding the top hinge.Lift door off bottom hinge. Replace Door Closure/Hinge Bearing. Reverse procedure to finish installation.
Other Parts Used:
-
Ken from Diamond springs, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers
15 of 23 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Shelf broke, and so did the ice actuator
Shelf just unscrew the old one and screw in the new one. Super easy. The ice actuator, after reading prior repair stories thought would be difficult. I did mine in 15 -30 minutes, and could not have been easier. Turn off power and get to work with a screw driver. Simple.
Other Parts Used:
-
Buddy from West Frankfort, IL
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
7 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice dispenser will not work
-
Ralph from ARGENTA, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Laura
June 4, 2019
If i ordered parts that i didn't need, can i return them for a refund?
For model number FRS6HR5JW0
Hello Laura, thank you for your inquiry! Our full return policy can be reviewed at the link below. Thank you.
https://www.partselect.com/Thirty-Day-Returns.htm
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS1526378
Manufacturer Part Number: 241681901
Manufacturer Part Number: 241681901
Brand
Model Number
Description