Product Description
Cabinet Rack Track - Right Side Specifications
This part is mounted to the side of dishwasher cabinet and helps the rack slide back and forth.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part works with the following products:
Dishwasher.
This part works with the following products:
KitchenAid, Jenn-Air, Kenmore.
Part# WPW10247511 replaces these:
AP6017723, 8564924, W10078218, W10247511
Customer Reviews
Filter By Rating:
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
Anthony N - October 14, 2020
Verified Purchase
Perfect fit. Easy fix.
Very easy repair, although if you were to follow some videos out there it would have been much more involved. If your brackets are in good condition, there is no reason to take out the dishwasher and change your plastic brackets.
- < Prev
- 1
- Next >
Customer Repair Stories
Average Repair Rating: 3.8 / 5.0, 4 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Top Cabinet Racks broken
Unsnap the end covers on the old sliding rack and slide the basket assembly out. This leaves the frames for the rack slide on the right and left side of the unit. Both sides snap out by twisting them downward. Remove the plastic brackets on the new racks by twisting them off. Snap new rack slide frames into the corresponding side of the diswasher. They are marked with an "up" arrow. Unsnap end covers on new rack slide frames and reinsert the basket assembly into the frames. Snap end covers over rack slides to trap the rollers into the slide. When you are finished you should dissassemble the strainer unit on the bottom of the dishwasher by the pump and remove all the small plastic balls that were part of the rack assemblies. They fall out and clog up the chopper assembly and pump.
Other Parts Used:
-
Mark from Wellington, OH
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers
30 of 36 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
top rack of dishwasher jamming
I purchased two new top rails and replaced them. It was a breeze. The racks actually "popped out" and I popped in the new ones! problem solved, I will buy from you again!
Other Parts Used:
-
barry from granby, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
3 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rack Tracks were broken
Loosen screws and pulled out dishwasher,
remove screws on the old rack tracks and screwed new rack tracks on. Pushed back in dishwasher and tightened screws. Very easy
to replace.
remove screws on the old rack tracks and screwed new rack tracks on. Pushed back in dishwasher and tightened screws. Very easy
to replace.
Other Parts Used:
-
Carolyn from Garland, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
3 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Center rack lost bears on track and was sagging
Replaced both right and left side rack slides. Had to remove dishwasher from cabinet as rack screws installed from the outside of the dishwasher tub. 4 screws total on rack slides. R and R of dishwasher out of cabinet and reinstall was about 1 hour to do. Disconnect water and drain lines to remove dishwasher. Not hard to do,
Other Parts Used:
-
Robert from CHINA GROVE, NC
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers, Wrench set
2 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Diana
December 5, 2017
Is this for the left hand side of dishwasher? Will it fit my Jenn-Air model jdb3650awy?
For model number JDB3650AWY
Hello Diana, Thank you for your inquiry. You would need part# WPW10247512 for the track for the left side of your dishwasher model. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11751023
Manufacturer Part Number: WPW10247511
Manufacturer Part Number: WPW10247511
Brand
Model Number
Description