This part is sold individually and does not come with push nuts. Must order the push nuts separately.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Leaking
This part works with the following products:
Dishwasher.
This part works with the following products:
Maytag, Amana, Jenn-Air, Admiral.
Part# WP99002589 replaces these:
AP6014446, 99002589
Customer Repair Stories
Average Repair Rating: 4.0 / 5.0, 3 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
leaking dishwasher
I first replaced the door seal and that did not stop the problem but noticed two little seals on the door. They were terribly worn so I unscrewed the door and cut the little washers that were holding the old ones in place. I replaced the seals and put the cut washers back on (I didn't have new ones) and it was done. All is well.
Other Parts Used:
Brooke from Edmond, OK
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
33 of 41 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The seals were deteriorated at the lower part of the door and allowed leaks. The door latch broke out twice, so replaced whole handle mechanism this time.
The repair is simple open the door and remove the perimeter screws and lift the door panel up. Be careful of attached wires. The handle only requires that you remove two electrical connectors and reconnect to the new latch handle and realign it with the screw holes in the door panel. The seals are not as easy to change they are attached with spring clips that I had to snipe through to get the old seals off. The new seals did not come with new spring clips, so I flattened the clips and reused them, they did not hold as tight, but seemed to work. Then just reinstall the panel.
anterior door, star allen set to undo, hot/neutral wires. will disconnect with some difficulty, ok to break. new latch is a large complete unit with new hot/neural wire attachments. The snaps that are apart of exterior of maytag are likely broken if the latch is but the anter start screws keep it more than stable. reassemble anterior with screws. its a good idea to order and replace the rubber corner door seals at the same time if the unit is some yrs old. very easy. they will snap off/on.
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Greg
July 24, 2019
So if my dishwasher did not originally have bottom door seals, how and where exactly do i install the replacement (part # 99002589)?
For model number ADB1500AWZ
Hello Greg, thank you for your question. This Bottom Door Seal for your model is located at the bottom of the Inner Door, number 8 on the Door schematic for your model. Good luck with your repair!
Was this helpful?
Thank you for voting!
James
October 21, 2021
does not have part 99002589 installed
For model number mdb6601aws
Hello James, thank you for writing. The part number for the Bottom Door seal you had referenced is PartSelect Number PS11747685. We hope this helps.
Was this helpful?
Thank you for voting!
Kelly
April 5, 2019
Replacing inner door panel, current existing panel does not have bottom corner seals (wp99002589)... are they necessary? because this unit sure didn't have them. it also doesn't have the metal support bracket across the top inside of the inner panel, is this also not necessary? could these items have been missed from the factory?
For model number mdb5601aws
Hello Kelly, Thank you for the question. Checking the model number information it does show the appliance does require these items and should have been included when the appliance was bought. Hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11747685
Manufacturer Part Number: WP99002589