Troubleshooting
This part fixes the following symptoms:
Little to no heat when broiling | Element will not heat
This part works with the following products:
Range.
This part works with the following products:
Whirlpool, KitchenAid, Kenmore.
Part# WP9757341 replaces these:
AP6013966, 9757341
Customer Reviews
Filter By Rating:
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
Maurice B - November 12, 2021
Verified Purchase
Great part easy repair
worked well
- < Prev
- 1
- Next >
Customer Repair Stories
Average Repair Rating: 5.0 / 5.0, 1 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Broil element blew itself out, looked like a welder
found the part here, once received, PULL Plug to stove. Removed 8 screws on back panel to remove two female electrical connections on element. Removed two screws from oven ceiling and two screws from back. Removed bad element, slid in new element, reinstalled holding screws for element, done inside oven. Connected female connections on each end of element, replaced back and 8 screws. plugged stove back in and tested Broil eelement, worked great. Wes
Other Parts Used:
-
Wesley from Johnstown, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
19 of 25 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Christine
December 13, 2017
The broiler will not heat. I assume i need a new broiler element? Also the oven works but it takes 20 minutes to preheat to 400 degrees. Is this the normal preheat time?
For model number GR673LXSB1
Hi Christine,
Thank you for your question. It could be your element that is the issue. I would suggest testing your element with a multi meter to double check and also testing your temperature sensor as well. The element should read between 0 - 50 ohms of resistance. The sensor should read between 1000 - 1100 ohms of resistance at room temperature. If both of those parts are working, it is likely that it is your control board that is the issue. I hope that helps. Good luck with your repair.
5 people found this helpful.
Was this helpful?
Thank you for voting!
Joe
July 3, 2022
Broiler does not heat. Took out old element and it measures 17 ohms disconnected. Good? I measured voltage with it hooked up and it was zero volts terminal to terminal. Not good? Measured each terminal to ground and got 121 volts.
The bake element and all burners work fine. The safety thermostat reads 0.2 ohms.
When the bake element is on, I get 240V terminal to terminal; 121V terminal to ground.
Does this sound like the broil element is toast or the control board?
For model number WERP4110PQ0
Hello Joe, thank you for your question. A bake or broil oven element's resistance may be in the area of 20 to 40 ohms depending on its wattage. We recommend replacing the Broil Element FIX11747198. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.
1 person found this helpful.
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11747198
Manufacturer Part Number: WP9757341
Manufacturer Part Number: WP9757341
Brand
Model Number
Description