Product Description
Defrost Heater Specifications
This radiant glass defrost heater is twenty and a half inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Fridge too warm | Freezer section too warm
This part works with the following products:
Refrigerator.
This part works with the following products:
Admiral, Magic Chef, Maytag, Crosley.
Part# WP60106-35 replaces these:
31-320, 60106-14, 60106-2, 60106-20, 60106-26, 60106-29, 60106-35, B81-116, WP60106-35VP
Customer Reviews
Filter By Rating:
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
Hazel R - June 15, 2021
Verified Purchase
Took know time to repair
My fridge was repaired and is working fine now. I hope it stays like that. Thank you the part.camr fast
- < Prev
- 1
- Next >
Customer Repair Stories
Average Repair Rating: 1.8 / 5.0, 2 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Fridge. freezing up
First I thank parts select for such fast shipment and correct parts.
The main problem was defrosting the coils between the freezer and fridge. The cover plate over the coils could not be removed untill some of the Ice melted.Removed freezer door, and screws each side of outer frige cover to enable cover plate to slide out.(Outer walls have to be pried out a little). R&R heater coil (shorted out and glass broken).Defrost thermo.located behind coils replaced as precaution. Defrost Timer located at bottom of fridge frame next to compressor. A couple of screws and unplug and plug in new part .(Also replaced as precaution-not qualified to test and dont want to do the job over) Thanks to google for info.First time for this job. You can do it.
Bob
The main problem was defrosting the coils between the freezer and fridge. The cover plate over the coils could not be removed untill some of the Ice melted.Removed freezer door, and screws each side of outer frige cover to enable cover plate to slide out.(Outer walls have to be pried out a little). R&R heater coil (shorted out and glass broken).Defrost thermo.located behind coils replaced as precaution. Defrost Timer located at bottom of fridge frame next to compressor. A couple of screws and unplug and plug in new part .(Also replaced as precaution-not qualified to test and dont want to do the job over) Thanks to google for info.First time for this job. You can do it.
Bob
Other Parts Used:
-
Robert from Salado, TX
-
Difficulty Level:Easy
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers, Socket set, Wrench set
31 of 50 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
freezer would not keep food frozen
First you must unplug the refrigerator, then remove the top hinge and freezer door, then you must remove the middle hinge to remove the refrigerator door, after that there are 4 screws located in the refrigerator compartment that must be removed that are holding the plastic control knob trim in place. When you remove these screws and drop the trim piece you can unplug the wiring on it, to completly remove it, next right above the plastic trim previously removed there is a metal trim with 3 screws holding it in place they will be removed now. Now you need to remove all of the shelving in the freezer compartment these pieces will just snap out , at the lower left and right sides of the freezer compartment there are two plastic tips that are attached to the main plastic body of this compartment they will need to be snapped out from behind the metal body of the refrigerator this can be done with a flat head screwdriver. Now pull straight out on the plastic body and it should come out , this will expose an insulating cover over the freezer coil where the defrost heater is located,if this is covered with ice you will need a heat gun which is a overgrown hair dryer basically. To melt the ice you will have to remove a insulating cover that is located behind the previously removed front metal trim it will come out by gently snapping it out of place, use caution during this step so not to break the cover in half. This will expose the front of the freezer coil and you can now use the heat gun to melt the ice, keep a check on the drain pan beneath the refrigerator as it will have to be emptied depending on the amount of ice build up. As the ice melts it should release the top cover of the coil and this will lift out of place also again use caution when removing the cover. With the coil exposed melt the remaining ice, if you look in the coil you will see the defrost heater, if the glass tube on the heater is broken please use extreme caution so you will not get cut by it , now you can unplug each wire from each side of the heater you may need a pair of pliers for this. when the wires are unplugged you can now lift out the bad heater again use caution if the glass is broken. There is a gaurd over the heater that will have to be removed by sliding it off the end wires when you have this off, slide it over the wires on the new element, now gently install the new heater back in the coil reconnect the 2 end wires and make sure they are connected good. you can now assemble all of the covers and parts in the reverse order you removed them, when assenbly is complete plug the refrigerator back in and in about three hours or so you should here the fan and compressor stop and the unit should go into a defrost cycle during this you should here the water running to the drain pan as it melts.
Other Parts Used:
-
chuck from dudley, NC
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Pliers, Screw drivers, Socket set
18 of 19 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11743094
Manufacturer Part Number: WP60106-35
Manufacturer Part Number: WP60106-35
Brand
Model Number
Description