Frigidaire, Crosley, Westinghouse, General Electric.
Part# 241649001 replaces these:
AP3903379, 1157268
Customer Repair Stories
Average Repair Rating: 4.3 / 5.0, 2 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Water Dripping from through the door water outlet and Ice Maker doesn't make ice.
I had two problems, the first was that water was dripping from the through the door outlet and the second problem is that the ice maker wasn't making ice.
Replacing the water valve was a simple process:
1. Turn off the water to the fridge at the household shutoff valve. 2. Move the fridge away from the wall. 3. Unplug the mains power (AC) plug from the wall power outlet. 4. Remove the 5 screws with a nut driver that hold the cardboard backing off the refrigerator. 5. (This is a great time to vacuum off the coils and underside of the fridge.) Disconnect the water supply from household plumbing with a box end wrench or channel lock pliers. I kept a large plastic cup and rag handy for the left over water in these hoses. 6. Remove the two screws from the water valve bracket on the right hand side and pull the water valve straight back from the fridge and line up the new valve in the same orientation. 7. Remove all the color coded electrical connectors (3 of them) and attach them to the new water valve. 8. Remove the remaining water hoses and attach them to the corresponding connectors on the new valve. 9. Dispose of the old valve and reinstall the new valve in reverse order.
The problem with the ice maker not making ice was because water was flowing so slowly from the valve that it was stopping in the fill tube at the back of the freezer and freezing stopping all water flow into the ice maker. I pulled the fill tube out of the back of the freezer from behind by rotating it 45 degrees counter clockwise and pulling straight out removing the ice blockage and drying the fill tube before I reinstalled.
Since I replaced the valve I had to take the cover off of the icemaker and set the water fill level down (screw toward the minus sign) and then adjusted it by checking the ice after each time it dropped and increasing the fill amount by 1 full turn (roughly 0.7 ounces) until it was just enough to make fully formed ice cubes.
The dispenser front panel cracked at one of the screw holes which caused the drip tray to fall out. This also caused a crack in the drip tray.
I removed the drip tray, exposing the screws on the bottom of the dispenser panel. I removed the three screws and lifted upon the panel to pull it out of the opening. From there I unplugged the power cord to release the old panel. I removed the power module from the old panel and installed it into the new panel. I then reattached the power plug and put it back in place. I screwed it back in and inserted the new drip tray.
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bruce
November 22, 2017
How do I remove the drip tray and the cover on the ice/water assy on the exterior of the door? Need to repair door finish around cover due to corrosion around it. Thanks...
For model number FRS26R4CW6
Hi Bruce,
Thank you for your question. You would have to use a putty knife to gently pry the frame from around the door cavity that it is set in. I would suggest putting masking tape over your putty knife so you do not scratch your appliance. I hope that helps. Good luck with your repair.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Gerrie
September 17, 2019
Can this be ordered in gray?
For model number 241649001
Hello Gerrie, thank you for writing. We would be happy to look into this, but we will need the model number for your appliance to do so. We look forward to hearing back from you!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Robert
July 17, 2019
Will drip tray model 241649001 fit the above model?
For model number FFSS2651TP1
Hi Robert,
Thank you for your question. This drip tray is listed for model number FFSS2651TP0. The model number you provided was not coming up either on our website or online and to verify if this will work for your model you will need to contact Frigidaire. Their telephone number is 1-800-374-4432 extension 0. If they provide you with a part number for the part, you may call us back with it and we can verify if we have it available for you. I hope this helps. Thank you and have a great day!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This solid element restorer is for ranges and cooktops. Solid element restorer restores and protects solid elements from rusting and spotting. Follow the instructions on the label when using this product.
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This low-odor gel, easily cleans away tough burnt-on deposits at room temperature. Apply the gel evenly on the cooled oven surface. Leave the gel to set overnight then wipe away with a clean cloth.
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS1148321
Manufacturer Part Number: 241649001