We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Paul
April 15, 2024
My oven will not light, all others will ignite. What is the problem?
For model number LSG4513ST
Hi Paul, thank you for the question. We would suggest checking the oven ignitor, part number PS3535362. It ignites the gas to light the oven burner. You may need to replace it to fix the issue. We hope this solves your problem!
Hi, I found following igniter part, Will this fit model lsg5513st. This igniter is for lsg4513st. Is lsg5513st and lsg4513st the same? please confirm me. See link: https://www.partselect.ca/PS3535362-LG-MEE61841401-Oven-Igniter.htm?SourceCode=19&SearchTerm=LSG4513ST&ModelNum=LSG4513ST
For model number LSG4513ST
Hello Tman, Thank you for your inquiry. Researching the model LSG5513ST that you have provided, we confirm that this igniter will also fit that model. Good luck with your repair.
Go onto youtube, such as https://www.youtube.com/watch?v=-ITkrwhDNMQ and watch similar videos for DYI. The process is very similar to other models.
Once the door is removed, place oven door on a towel or soft place so it does not scratch the door. Unscrew the screws and make sure you notice where each screw goes, so you know the process of where each screw goes when you re-assemble.
Once the inner cover is removed, remove the insulation, too so you don't damage it. Use Wet/Dry Shop Vac to clean the shattered glass. (WORD OF ADVICE: I did not remove the insulation and the suction of the Shop Vac removed part of the insulation, so now instead of a quick turn around repair turns into a few weeks repair, because the insulation is on back order 10-14 days from the supplier. DON"T MAKE THE SAME MISTAKE!)
Once the glass has been removed, the new inner glass is replaced, begin by re-assemble the oven door with the correct screws and attached the oven door to the range.
Took off the oven door then took out the racks and two screws in the oven bottom and removed it . Then removed the heat deflector. Then un plugged the old igniter and removed the burner to make it easier to remove the old igniter. Then installed the new igniter and reversed the process
As soon as my husband put it in the oven, the very thin prongs broke. There was no guard on either side of the prongs for protection like the one that had been in there. Very costly to us of $185 with no fix. Very disappointed in that ignitor. It would have been an easy fix. Had replaced one previously but it only lasted 6 months. Now we have a new stove
