The dishwasher roller assembly connects to the dishrack, and is located in the lower level of the dishwasher. It allows the dishrack to easily slide in and out. If the lower rack keeps falling off the...
This part is the replacement inlet valve for your dishwasher. It is approximately 4-1/2 inches by 3-1/2 inches. The water inlet valve in your dishwasher connects to the water source and solenoid wire...
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
7 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Karen
June 14, 2023
I need to order the control panel and door handle as it has two thin cracks in it. What is the part number
For model number LDP6797BD
Hi Karen, thank you for getting in touch. According to our research on your model, the control panel assembly, part number PS16662007, houses the controls and also acts as a handle for opening and closing the door. If you require assistance to place an order, please contact customer service!
Hello Carla, thank you for contacting us. According to our research, we would recommend checking the control panel, part number PS16662007, to fix the issue. We hope this helps!
Why am I constantly getting a moldy smell from the dishwasher when I open it? I cleaned out the drain at the bottom but there is always standing water which I think is giving off the order. Do not know why it is not completely draining. I did not install this. It was professionally installed so I am assuming they did the right thing.
For model number LDP6797BD
Hello Mike, thank you for your query. We have found that even if your drain hose is not kinked or otherwise obstructed with food waste, it could still be the reason why your dishwasher smells. If your drain hose drops from the back of your unit and runs along the floor before moving upward towards the sink, gravity could be working against you. If you have a drooping drain hose, try to find a way to reposition it. Ideally, your drain hose will run downwards from the dishwasher into the sink disposal, allowing gravity to do most of the work. If the dirty water and food waste do not have to go upwards to the disposal, they are less likely to get stuck and create a bad smell in the hose. You may need to check the drain filter for clogging and reposition the drain hose, part number PS16621806, to fix the issue. We hope this helps, good luck with this repair!
Part Replacement: Repair was quick and easy, requiring small Phillips screw driver, multimeter, flashlight/light source, (gloves and safety glasses optional). Steps:
1. Turn off power to dishwasher at breaker box. 2. Remove any screws securing DW to cabinet and slide out DW (about 12-18 inches) to expose switch (located on the very top exterior front). 3. Remove thin plastic cover sheet held in place by one Phillips screw. 4. Test for ac power or if unsure about turning off DW power. 5. Unplug two wiring assemblies (left and right side of old part). 6. Remove two small Phillips screws holding part to DW. (Tip- put a large towel/drop cloth down below screw location to catch screws should they fall.) 7. Manipulate the old part out (jiggle, twist, slide backwards, etc.) 8. Install new part and follow above instructions in reverse order. 9. Test DW.
Hope these instructions are helpful. Best of luck on your project!
Ordered the roller from Parts Select, slid the roller over the little spindle sticking out of the bottom rack and snapped it in place. Job done in less than one minute.
