Models
>
FFGF3016TBB
FFGF3016TBB Frigidaire Range - Overview
Sections of the FFGF3016TBB
[Viewing 5 of 5]Keep searches simple, eg. "belt" or "pump".
![Light Bulb – Part Number: 316538904 Light Bulb – Part Number: 316538904](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/12751166-1-S-Frigidaire-316538904-Light-Bulb.jpg)
Light Bulb
PartSelect #: PS12751166
Manufacturer #: 316538904
Clear, 120 Volt, 40 Watt.
$25.08
In Stock
![LP Conversion Kit – Part Number: GRLP4 LP Conversion Kit – Part Number: GRLP4](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/3633782-1-S-Frigidaire-GRLP4-LP-Conversion-Kit.jpg)
LP Conversion Kit
PartSelect #: PS3633782
Manufacturer #: GRLP4
The LP conversion kit is used in ranges
$99.90
In Stock
![PROBE – Part Number: 316233903 PROBE – Part Number: 316233903](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/11731754-1-S-Frigidaire-316233903-PROBE.jpg)
PROBE
PartSelect #: PS11731754
Manufacturer #: 316233903
Note: Connector could be different than original. If so cut & splice wires together with porcelain wire nuts.
$33.74
In Stock
![LEVELING LEG ASSY – Part Number: 5304509869 LEVELING LEG ASSY – Part Number: 5304509869](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/12364627-1-S-Frigidaire-5304509869-LEVELING-LEG-ASSY.jpg)
LEVELING LEG ASSY
PartSelect #: PS12364627
Manufacturer #: 5304509869
Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.
$9.81
In Stock
![CONTROL – Part Number: 5304518661 CONTROL – Part Number: 5304518661](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/12717913-1-S-Frigidaire-5304518661-CONTROL.jpg)
CONTROL
PartSelect #: PS12717913
Manufacturer #: 5304518661
This part is a replacement electronic clock/timer for your oven. The clock timer will display the time, and can be used to set a timer. If the clock will not start, will not allow you to program the t...
$205.88
In Stock
![Oven Door Seal with Clips – Part Number: 316239700 Oven Door Seal with Clips – Part Number: 316239700](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/440011-1-S-Frigidaire-316239700-Oven-Door-Seal-with-Clips.jpg)
Oven Door Seal with Clips
PartSelect #: PS440011
Manufacturer #: 316239700
Also known as gasket.
$152.52
In Stock
![Anti-Tip Kit – Part Number: 316112005 Anti-Tip Kit – Part Number: 316112005](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/3655242-1-S-Frigidaire-316112005-Anti-Tip-Kit.jpg)
Anti-Tip Kit
PartSelect #: PS3655242
Manufacturer #: 316112005
This kit comes with two installation screws.
$18.73
In Stock
Questions And Answers for FFGF3016TBB
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the FFGF3016TBB
[Viewing 10 of 10]Little to no heat when baking
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/11731754_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12071409_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12717913_1_S.jpg)
Show All
Will Not Start
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12717913_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/11731754_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12071409_1_S.jpg)
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12071409_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/446204_1_s.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/11731754_1_S.jpg)
Show All
Element will not heat
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/11731754_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12071409_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12717913_1_S.jpg)
Show All
Touchpad does not respond
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12717913_1_S.jpg)
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12114509_1_S.jpg)
Show All
Oven is too hot
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/11731754_1_S.jpg)
Show All
Oven not heating evenly
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/11731754_1_S.jpg)
Show All
Will not program
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/12717913_1_S.jpg)
Show All
Gas smell
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/16218309_1_s.jpg)
Show All
Little to no heat when broiling
Fixed by
these parts
these parts
![Fixing](https://partselectca-dsfph5cffxaaesb6.z01.azurefd.net/assets/PartImages/11731754_1_S.jpg)
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Safety valve would not open
I am an HVAC tech by trade so it wasn't difficult to diagnose problem with safety valve. The hard part was being without an oven for a week. Repair was simple and effective--oven works good as new.
Shut off gas and unplugged oven. Removed floor of oven between broiler and bake section, used wrenches to disconnect gas line from safety valve in back of oven, used philipps head screwdriver to remove burner assembly and gas valve, reversed process to replace. Checked out operation--OK.
Shut off gas and unplugged oven. Removed floor of oven between broiler and bake section, used wrenches to disconnect gas line from safety valve in back of oven, used philipps head screwdriver to remove burner assembly and gas valve, reversed process to replace. Checked out operation--OK.
Parts Used:
-
Ed from Darby, PA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Screw drivers, Wrench set
125 of 157 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
We had a transformer go out in our block and made a surge which blew out the electronic oven control
The repair of the oven was really easy . I removed a total of 7 screws with a 1/4 inch nut driver to remove the back cover of the instrument panel. I then unplugged the wires from the from the oven control and with a phillups screw driver I removed 4 screws that hold the oven control,the face plate with the words on it has to be taken off the old control and put on the new one . I then installed the new oven control by putting the 4 screws back on and plugging back the wires. I then replaced the back cover with the 7 screws and plugged the power back in the outlet, The clock has to be adjusted and your done.
Parts Used:
-
Alberto from Houston, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
87 of 99 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Range would not come on
Turned off power, took back off stove removed old probe.
I had to splice wires since new probe ends did not match up.
the instructions were to splice the wires. I had the breaker off for about 3 hours. this is not in the instructions, but being a widow, I had to ask a few people why it would not come on after I connected the wires.
After waiting, I turned the breaker on and my range came back on.
I had to splice wires since new probe ends did not match up.
the instructions were to splice the wires. I had the breaker off for about 3 hours. this is not in the instructions, but being a widow, I had to ask a few people why it would not come on after I connected the wires.
After waiting, I turned the breaker on and my range came back on.
Parts Used:
-
MaryLou from Monroe, NC
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
103 of 188 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!