Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Roger
February 11, 2020
Error 1. Cant get error off, says it's a leak?
For model number EIDW6305GS1
Hello Roger , Thank you for the question. Yes, the Error 1 indicates there is a leak somewhere. We suggest looking the appliance over to see where the leak may be coming from. Check all hose connects and the Valve to be sure there is no damage or wear. We hope this helps.
Was this helpful?
Thank you for voting!
Stan
July 5, 2021
What does er03 message mean? Dishwasher will not cycle even to soap action. Is this repairable?
For model number EIDW6305GS1
Hello Stan, Thank you for the question. The 03 error code on an Electrolux dishwasher indicates failure of the wash motor. We first suggest checking the wiring to make sure nothing came loose. Also check the pump for a blockage or clog. If everything is clear, the Motor will need to be replaced. We hope this helps!
Disconnect from power Unscrewed 4 phillips screws from top of outer door. Unscrewed 2 screws each siide of door. Lower outer door section drops away. Note wiring sequence on dispenser, then disconnect wires. Unscrew 6 screws on dispenser and lift dispenser out.
Place new dispenser in place (note orientation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw. Reconnect wires to dispenser correctly. Slide lower outer door over tabs and secure with the 4 side screws. Ensure lower door is up under control panel and secure with the 4 top screws.
Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
I was able to pull out the top basket were the glasses are put then I lined up the back and the center plastic clip an slid on the center spray arm. It took about 2 miniutes
The only difficultpart was to figure out how to remove the stainless cover from the door. Seems it slides upwards after screws are removed. After that it is self explainatory and goes back together in 5 minutes.