This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.
This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the spl...
This part changes the transmission from agitation to spin mode. This actuator is for washers.
Actuator shifts the splutch and monitors the position of the splutch.
This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
This part is the replacement lid latch or latch assembly for your top-load washer. The lid latch holds your washer door closed, and allows the washer to run its cycle. If the lid latch is damaged, you...
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time
$190.82
In Stock
Questions And Answers for 11021302010
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Rick
October 13, 2023
water drips into the tub when cycle is done.
For model number 11021302010
Hi Rick, thank you for the question. If water is dripping into your washing machine when it is turned off, there may be a problem with the washer inlet valve, part number PS11753661. This valve allows water to flow into the tub during a wash cycle. Good luck with this repair!
Washer will not advance from the wash cycle. What is the problem?
For model number 11021302010
Hello Lily, thank you for reaching out. We believe your washer is having this problem because of the faulty shift actuator, part number PS11747977. It shifts the splutch and monitors the position of the splutch. You may need to replace it to fix the issue. We hope that helps!
Do you have any insight on why my washer won't agitate or spin? I can hear the locking mechanism engage and disengage and it does lock.
For model number 11021302010
Hello Craig, thank you for reaching out. Based on our research, the issue is most probably with the drive belt, part number PS11747978. We would recommend replacing it to fix the issue. Glad to be of help!
A detailed Service Technician Service Manual is hidden inside the machine on the front panel. It is hidden by the bleach dispenser input. It gives a list of fault codes and instructions for calibration after repair, resetting fault codes, and a manual test mode for stepping the machine through each mode on command. The Tachometer failed which would not let the machine come up to maximum spin speed. The tachometer is part of the solenoid actuator that shifts the transmission. It is not specifically called out in the manual. Any failure causes the lid lock light to blink which gives the appearance of a lid lock failure
The instructions that came with the part were worthless. Essentially, unplug, put in new part, plug it back in. I spent a considerable amount of time on the internet and finally found a video showing how to open the top. Unlike other models, it is held down by clamps in the back rather than clips in the front. Once finding this information the installation was simple. Remove the clamps and the back of the console, slide the top forward and lift, remove and replace the lock and reassemble. You don't even have to remove the hoses.